Recent content by RickHB19

Check to se if it hits the stops both ways and measure the wheelbase on both sides

Yes, just ask for a rear brake hose. The splitter you want is part of it. If you have a few inches of lift, you may want to get one for a 95 wrangler, its plenty long. Good Luck

Sounds like you have a bearing noise in your trans. The input shaft stops when you push in the clutch.

I havent seen much on this, but how much current would be enough to run the 4.0? How cheap are the parts?

For better flex they should be on more of an angle. I plan to move the shackle mount forward 1-2 inches with my next bastard pack. I have read, and it makes sense that a verticle shackle is no good for ride or flex. Any luck with it yet?

I plugged off the intake with my hand and it ran just fine.(I did have mechanics glove on.) If, by this you mean you sealed off the throttle body completely, and it still ran fine? You have a big vaccuum leak somewhere, did you spray the brake booster for leaks?

How dirty is your throttle body and idle air controler?

Just a thought. Due to spacing the injector from the head. How much will something like this effectively retard fuel timing? And would it cause anything good or bad?

Keep what you have, the way you have it. Get an amp with the crossover built in for ease of install. The only other thing you should need is an amp install kit, which shold include simple instructions how to wire it all up. good luck

Fold the seam with a BFH.

What does your shackle angle look like?

Yes. Seperate the power Wires from the signal wires, this can help cure your noise.

As long as you can make a panhard bar that won't crush your oil pan or exhaust, I think it would work, with enough support. I would add some to support it laterally. Just my $.02

X2 :patriot:

Rick Anderson, I just reread my post from last night and I wanted to appologize if I came off as a D!ck. I thought most of your ?'s were right here: Bone stock 92 cherokee, I have replaced:Steering stabilizer, two weeks ago Trac bar and shock absorbers, today. I used a buddies lift to get...