Recent content by justfalcon

To clarify, my high idle issues were 100% solved by readjusting the TPS. Don't know why a TPS would cause an exhaust/fuel smell...No longer any fumes in the engine bay, just when standing towards the center of the jeep.

As far as the gas/exhaust smell that's lower on my concern list than the backfire/misfire issues in the video. I can just go get a new TPS later today and swap that out - unless you're saying a TPS (which didn't cause this issue before) is causing this issue now?

Video Link: https://www.youtube.com/watch?v=faKKO7SoSvU&feature=youtu.be Sound on / up loud https://youtu.be/faKKO7SoSvU Did cruiser54s throttle body mod - tapped npt fitting and ran new line to a brand new MAP sensor - fixed idle startup issues right away. Cleaned TB, new gasket, etc. Got...

Ok everything is connected properly - still not getting anything through the vents under the "Heat" setting. Defrost seems to work fine - still have not tried any AC settings. Vent seems to be the only thing pushing air through and really only through the center vent. Side vents are...

But it could be that somewhere along the years there was something (switch maybe?) between this connector and the light, as it's really the only thing that makes sense to me too...it doesn't appear to affect anything that I've noticed yet so it'll sit for the time being...

But it could be that somewhere along the years there was something (switch maybe?) between this connector and the light, as it's really the only thing that makes sense to me too...it doesn't appear to affect anything that I've noticed yet so it'll sit for the time being...

Was my first thought - this mystery connector's cable would be long enough for that but the light has a spade-type connector and doesn't fit up at all... The light is currently unplugged entirely and this mystery connector is the only thing that isn't connected anywhere in the engine bay...

The million dollar question is though - what the hell is this plug for? It appears to be coming out of the same part of the harness the blower motor connector comes out of but haven't been able to figure it out for the life of me...

Ha - yup that diagram would have helped awhile ago. That's the one I couldn't find anywhere... That's basically how I've got it set up but with all new silicone lines and it's getting mounted under the coolant reservoir Did all new calipers in the front so I'm off to bleeding and turns out...

Ahhh I see - so if I T'd off the source and ran two sources to the 6mm and just ran one 4mm out to HVAC and one 4mm to CC/TC that'd solve the issue then?

And if the case is that rezzy is too large or just toast in general, would replacing it with any rezzy work in theory? I have an extra one of these laying around from my BMW that's got 4mm nips that'll work just fine...

also don't mind the mess - that pic isn't how it's set up in my diagram, but that's how it is currently set up. Also am deleting that cluster**** with the intake vacuum harness today as well and just running straight silicone lines.

Oh really? This is what was mounted under the fender so I assume it was factory... Currently that's how it's set up Intake Source goes into 6mm, while other 6mm is blocked and the two 4mm are used as sources to hvac and tc

Sorry I'm only really messing with this jeep on the weekends. I'm going to avoid doing the vacuum mod for the time being until everything else is sorted out. I am going to look into moving the ground today as well. I blocked all outlets on the rezzy and it's holding vacuum - so one would...

I figured that was the case. I can keep doing that and a few more cycles of cooldown/run. Still not 100% sure the vacuum is hooked up correctly - I am not, since I started at this again, getting anything at all from the "Heat" setting - defrost works, vent works...