Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
Welcome to the new NAXJA Forum!
If your password does not work, please use "Forgot your password?" link on the log-in page.
Please feel free to reach out to [email protected] if we can provide any assistance.
What method was used to test for exhaust in the coolant?
I just had a customer have similar issues ( higher cruising temps than yours) and his issue was caused by a reverse rotation water pump. No external difference between the 2 pumps could be seen.
Sentry lock usually takes 3 start attempts with failed sync on the ngc3 is it the same with the JTEC+? The dealer can unlock the PCM or if you know some cool people they can also unlock it or disable the skim completely.
I installed the same/similar lights in the first link and can confirm it has DRL without the DRL feed hooked up and the headlights/marker lights off. The engine must be running.
It has wifi DRL
Install a wideband sensor. Boost and timing advance are not something you want to do. You can advance the timing in the 1bar section of the map just shy of the transition zone. I wouldnt do anything with the timing or run the engine above 1 bar until you check your AFR on the WB.
Advancing the CPS does add some power but you will need to run at least midgrade possibly premium if you experience any knock.
The 96 and up ecu can be re mapped to achieve a timing bump as well. It can even be tuned for forced induction.
The distributor phasing sensor/cam shaft sensor is the flat one under the distributor cap. If the shop is connecting to the obd2 port and the reader will not connect at all to the pcm with key on engine off then the pcm does not have power. Check all fuses in the PDC. Then the C1 (black)...
After having issues with quality CPSs with every aftermarket supplier I wondered if I could do better. Long story short I wanted a neodymium magnet tipped cps that would last as long as the factory unit. After finding a manufacturer and talking with the lead engineer we came up with a pretty...
I typically will buy the splash brand as it is just methanol and water. The red stuff is appx 30% meth and I would use it for the windshield and injection. In the engine, not me. CT only gets down maybe to -4 and no clogging issues. A bottle of isopropyl wont do any harm as methanol is far more...