Recent content by CREEPRS

new pictures of interior and beadlocks are at the webshots address listed in the first post

Ok price drop to $11500.00

Greg, I sold the JeepSpeed a few weeks back.

Still have not sold, take a look

-1997 Jeep Cherokee 4wd -Custom lift and susspension (Long-arm front and four link rear with coils) -Atlas II 4.3 t-case -Ford 9" rear with detriot locker, disc brakes, 5:43 gears, Currie chromoly shafts -Dana 44 with New Detriot Electrac, 5:38 gears, Yukon chromoly shafts...

I run the 22 gallon alum cell from summit, bought an EFI external pump from a TPI shop local paid $200 for it. Funny you mentioned the foam, never thought about changing it, I have had it for about a year and now every so often my truck acts like it has a clogged filter and the pump runs real...

Also do forget, SYE, shocks, and tires. With that high of a lift you may need the SYE.

I built special body stands for mine, they went under the front frame and on the rear bumper mounts they stood about 4' tall and when I put my axles on I had to lift it higher to get my tires on. Then again I am running 40" tires, trust me, I sadi 12 ton stands because I do not like to be under...

OK, THe 4.5 does have big springs, here is the best way, go buy the 12 ton jackstands, I think they extend to like 36", put a floor jack under the pumpkin, raise the vehicle up and place the jack stands under the frame as close to the leaf hangers as possiable, getting the jack stands as high as...

To answer your second question, yes you can change it to a big bearing housing, just buy the flanges(about $75 for the pair) take to a shop that does this type of work and pay them to weld them on straight, or you could do it yourself, it will be cheaper to buy a new housing, they go for about...

ashman, I did not mount the ram to the frame, it is mounted to the axle and to the tie-rod, I did not blow a gearbox, I snapped one of the bolts on my track bar mount, and the other one worked it way loose.

Twisted, I have some excel documents, that will help you figure out angles and stress loads of the arms at differant angles, The three link wishbone, is not really that much more differant then a four link, if done correclty, shoot me an email offline to [email protected] to remind me to send...

yea, but no where to post, I will post some on webshots

It's not so the ram bigger then the box, its the box pulling the ram futher then it's stroke, which can be fixed by setting it up correctly, in the first place. I think that this thread is not really about the parts breaking its that when you start buying geto fab parts to make a system work is...

Yea Sean is the one getting mine set up, good guy.