Recent content by canadian-xj

Maybe check your engine mounts as well?

oohhh oohh what do i win? How much and does it keep the disk brakes?

DO NOT deal with CREASYS OFFROAD!!! Teribile buisness practices!!!

non c clip?

if u could email me your contact info that would be great. My email address is [email protected] Thanks Marco.

Also could anyone point out the cheapest place to purchase it online or maybe a naxja vendor.

just a bit nervous about hiem joints on steering. Wonder if u could run a tre instead of hiems? Would it be better or are hiems better. Also wondering as the hiems where, if they get noisy? Wonder if u could swap em out for some re super flex bushings.

Just wondering which steering system i should go with? I have a cherokee with 7" lift and 35's. Cant decide which of the 2 systems to go with. Some input from people with either system will be great.

Why no hiems, Because they get noisy with time. Wonder if that u turn kit will work with my abs on my xj. Its a 91.

Seen this setup on phatjeeps.com http://www.phatjeeps.com/conversions/grnd_chk_steer.htm I like the design but not into using heim joints on the street. I am looking for a similar design but with tre on the end instead of heims. I tried out the tera flex kit but it is junk. Had to send it...

the autometer a/f gauge is nothing more than a pretty light show. It also will only read when u load the motor at wide open throttle. Most efi vechiles also ingore the 02's at wot. I would do a dyno pull to get correct a/f readings.

Can u say vibrations or more like womp womp womp.

actually it is called track-lok.

thnx for the info on your site gottabejeep. I probaly need more bumpstop length in the rear.

well my 33's rub like crazy on the back with trimming. Wanting to go with some 35-14.50. I would go with crazy fender trimming but i like my sheetmetal too much right now. What works for u might not work for everyone else.