Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
Welcome to the new NAXJA Forum!
If your password does not work, please use "Forgot your password?" link on the log-in page.
Please feel free to reach out to [email protected] if we can provide any assistance.
http://onslow.craigslist.org/cto/3112200575.html
Pretty much a project Jeep I got in a trade that I can no longer work on. The ad pretty much says it all, but make me an offer!
I'd like to find a '99-01 XJ and do a 1 for 1 swap, stock for lifted if anyone is interested. I'm also interested in selling it outright if someone has a decent offer. I'm currently in Hawaii and will be back on the east coast come August but my family lives in VA and can show the Jeep. I've...
Exactly. I should have been more clear. With no HAZ and the way the weld sits, combine with no evidence of undercutting, I'd say the weld wasn't hot enough. Just saying that when I was learning, I'd either have too much amperage and undercut or I'd run it too low and not get the penetration...
Just an observation, but I would spend more time on the plate than the tube. The weld looks like it is mostly on the tube vs the plate, but it could just be the picture. If you took a right angle and put a circle right in the corner, that gap between the edge of the circle and the point of the...
If I may revive this old thread, 5-90, what would the oiling characteristics be of these lifters in their failed conditions? As in, if I were to have the engine running and the valve cover off, would a failed lifter still be pumping oil to the top? How would you identify the failed lifter...