montanaman
NAXJA Forum User
- Location
- Western Montana
Time to rebuild my '91 NP231-J (with the long tailhousing).
I need recommendations for the following:
- Does my version have the 16mm or 24mm input bearing? I think it's the 24, but not sure.
- A good rebuild kit with high-quality Japanese or US bearings. No Chinese crap.
- A Heavy-duty SYE ... advance adapters? PORC? My lift will never be over 4", so I don't think I need the extreme short shaft.
- A good driveshaft supplier.
Any other recommendations, while I'm at it?
Edit: I bought a made-in-the-USA Cloyes chain a few years back. Are they any good?
And here is a newbie question ... would it be possible to get my driveshaft balanced with both of the yokes attached? Wouldn't that be a better solution than just balancing the shaft alone?
Thanks.
I need recommendations for the following:
- Does my version have the 16mm or 24mm input bearing? I think it's the 24, but not sure.
- A good rebuild kit with high-quality Japanese or US bearings. No Chinese crap.
- A Heavy-duty SYE ... advance adapters? PORC? My lift will never be over 4", so I don't think I need the extreme short shaft.
- A good driveshaft supplier.
Any other recommendations, while I'm at it?
Edit: I bought a made-in-the-USA Cloyes chain a few years back. Are they any good?
And here is a newbie question ... would it be possible to get my driveshaft balanced with both of the yokes attached? Wouldn't that be a better solution than just balancing the shaft alone?
Thanks.
Last edited: