Ben824
NAXJA Forum User
- Location
- Woodstock, GA
Ok guys I have a 97 XJ that I dropped a rebuilt 92 4.0 in my Jeep. I used nothing from the 92 other than the oil pan. Everything else was swapped over and I made sure to plug the rear temp sensor hole. I put on a new water pump, fan clutch, radiator was two months old before the old engine went bad and it's a CSF 3 row radiator which I have used before and it was consistently 200 until the last one went bad, and the thermostat was also replaced when the radiator was. The Jeep sat for 7 months before the new engine was put in. I had the radiator inspected by a local radiator shop before I reused it. I burped the system several times and there is no more air in the system.
When I am in heavy stop and go traffic, it begins to overheat slightly above 210 to about 215 or so. I cannot for the life of me figure out why it is STILL wanting to overheat! Any suggestions?
When I am in heavy stop and go traffic, it begins to overheat slightly above 210 to about 215 or so. I cannot for the life of me figure out why it is STILL wanting to overheat! Any suggestions?