muddeprived
NAXJA Forum User
- Location
- PA
Can someone help me figure out what's going on with my setup? I'm trying to run the putco headlight wiring harness with new bulbs.
To start off, my passenger light was dimmed pretty bad but the driver's side was fine. I installed the harness like everyone else did (read a bunch of threads on the install, too easy) but when I turn on my lights, they don't turn on. Turn signals work. I got 12 volts going in and coming out of the relays BUT no power at the putco bulb plugs. My factory bulb plugs look corroded a bit but I still can read 12 volts from them. Both putco plugs are grounded (driver's side to the small bolt behind the turn signal housing and passenger side to the radiator support bolt. Paint removed). I'm running 20a fuses if that matters and all wire connectors checked out tight. I'm puzzled on how the wires coming out of the relay registers 12v but the same wire at the bulb register nothing.
Any thoughts?
Thanks
To start off, my passenger light was dimmed pretty bad but the driver's side was fine. I installed the harness like everyone else did (read a bunch of threads on the install, too easy) but when I turn on my lights, they don't turn on. Turn signals work. I got 12 volts going in and coming out of the relays BUT no power at the putco bulb plugs. My factory bulb plugs look corroded a bit but I still can read 12 volts from them. Both putco plugs are grounded (driver's side to the small bolt behind the turn signal housing and passenger side to the radiator support bolt. Paint removed). I'm running 20a fuses if that matters and all wire connectors checked out tight. I'm puzzled on how the wires coming out of the relay registers 12v but the same wire at the bulb register nothing.
Any thoughts?
Thanks