Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
Welcome to the new NAXJA Forum!
If your password does not work, please use "Forgot your password?" link on the log-in page.
Please feel free to reach out to [email protected] if we can provide any assistance.
i have a 99 xj and i am looking for a drop pitman arm i am told to run the zj arm is this the correct one Jeep grand cherokee wagoneer 92-98 would this work?
From L to R, stock CJ pitman (straight) arm, a stock YJ/TJ arm (2.5" of drop), a stock XJ arm (3.5" of drop), and finially an aftermarket XJ arm measureing at 4.5". This aftermarket one is from rusty's and should be pretty close to the drop from a ZJ arm.
Mine ZJ one was exactly 3/4" drop down from a stock XJ. You do realize you cannot not 'just' fit one of these without then dropping the frame bracket for the trackbar exactly 3/4" or raise it 3/4" at the axle end to keep the two parallel. If you dont you WILL get bumpsteer which is when the Jeep will steer itself after hitting a bump or pot hole without any steering input from the steering wheel.
With a 6.5" lift I shouldnt have to move the trac bar though, Right? I was told with a 6.5" lift that I need a 1.25" drop pitman. I can get a ZJ pitman arm for $8 figured the .25" wouldn't make that much of a differance and would save me $50. I also intend to go to an 8.5" long arm setup sometime in the next year so I would have to change it again.
Well put the drop pitman arm of a 97 grand cherokee and my trac bar and drag link are inline now. The little bit of bumpsteer I was getting is gone and had it up to 80 mph coming home from wheelin today and she rode perfect.