Another control arm question

I am trying to install some teraflex adjustable control arms and am having a little trouble with it. When i put the control arm up to the mount, they are just a little to wide for the mount. I just put new bushing in the arms and don't know if that is the reason or not. Should i just try and pry out on the mounts a little to make the arms fit or what should i do?

Thanks,
Ben

My RE arms were tight also. I just tapped the mounts with a BFH and went right in. Just tap them open a bit it won't take much.

If they are too tight, try a piece of all thread rod, a couple of nuts and couple of big washers. Mount this set up inside the CA pockets, then spread it open with a couple of wrenches....