Ra-kez
NAXJA Forum User
- Location
- Oak Harbor, WA
how do you remove the shafts from the housing????? There aren't any retaining bolts like an xj 44, does the shaft just pull out? Any help would be great thanks a lot.
-
Welcome to the new NAXJA Forum! If your password does not work, please use "Forgot your password?" link on the log-in page. Please feel free to reach out to [email protected] if we can provide any assistance.
isuzu dana 44 question
- Thread starter Ra-kez
- Start date
Ra-kez
NAXJA Forum User
- Location
- Oak Harbor, WA
nevermind..........pretty embarassing that i even asked in the first place. I figured it out, i just tightened a chain onto the lugnuts and yanked it a couple times and......presto removed axle shaft
90Blue_XJ
NAXJA Forum User
- Location
- In yer postz fixin yer spellinz.
Was it held by anything or just pressed in? What keeps you from loseing the axle going down the trail?
Just asking cause I don't know anything about Isuzus at all. Didn't know until recently they had D44s.
Just asking cause I don't know anything about Isuzus at all. Didn't know until recently they had D44s.
Ra-kez
NAXJA Forum User
- Location
- Oak Harbor, WA
its held on by the plate that the brake caliper and backing mount to, you just remove the 4 bolts on the back of the backing plate and give a good tug. the bearings and seals are held onto the axle by a snap ring.
- Location
- Thornton, CO
cjrakes said:
You mean a lock collar?
