Acos coil spacers bolt size?

I

indy30

NAXJA Forum User

Location

Maryland

• Jun 9, 2006

• #1

Hey all,
I purchased a set of these adjustable coil spacers at Ebay a while back and want to finally put them on my 99 XJ. They didn't come with mounting bolts. I'd appreciate if someone could tell me what I need to get from the local hardware store (size ,thread, length, etc).
Thanks!
Mike

 

R

Roads

NAXJA Forum User

Location

Portland, OR

• Jun 9, 2006

• #2

There is a single bolt that goes up through the center and into your stock bumpstop. Your going to have to cut your bumpstop just above the weld. Then slide the ACOS over it and then thread the bolt into the bumpstop

 

I

indy30

NAXJA Forum User

Location

Maryland

• Jun 9, 2006

• #3

Simple enough!
Thanks!
Mike

 

K

keel5

Member #1064

Location

Mercer County, NJ

• Jun 10, 2006

• #4

I had to tap the hole in my bump stops. Therefore you can make them any thread you want.

 

X

xjgrn

NAXJA Forum User

Location

Winchester N.H.

• Jun 10, 2006

• #5

Its a metric, you'll need a tap. try the jks site, they may have directions

 

xjtrailrider

NAXJA Forum User

NAXJA Member

Location

Roanoke VA

• Jun 10, 2006

• #6

I think mine took a 10mm tap corse thread I don't remember the exact thread count.