yellowxj
NAXJA Forum User
- Location
- Ocala, FL.
would the 2.5" JJ w/ 1" stud work for the subframe side of my radius arms??? strong enough? or should I weld them or superflex joints straight to the tube??? opinions?
-
Welcome to the new NAXJA Forum! If your password does not work, please use "Forgot your password?" link on the log-in page. Please feel free to reach out to [email protected] if we can provide any assistance.
johnny joint or super flex
- Thread starter yellowxj
- Start date
BrettM
NAXJA Forum User
- Location
- michifornia
I think that stud would bend if you make a habit of dropping on rocks (also depends on how much stickout you have). It will be plenty strong though for the torque loads though.
JeepFreak21
NAXJA Forum User
- Location
- Cameron Park, CA
How big's the shank?
Billy
Billy
yellowxj
NAXJA Forum User
- Location
- Ocala, FL.
its a 1" diameter stud 3" long, seemed like it would make fine tuning easy...course my heep is a little past fine tuning...
Roxtar
NAXJA Forum User
- Location
- NW Indiana-Chicago area
What I don't like about having the studs pre-welded on is that they're too short. I prefer to have more thread contact in this situation.
More room for adjustment and stronger.
The other advantage of DIY is that you can use right and left hand threads.
Few things better than being able to adjust the arms without removing them.
More room for adjustment and stronger.
The other advantage of DIY is that you can use right and left hand threads.
Few things better than being able to adjust the arms without removing them.