Zuzu 44 pinion "yoke"

I am prepping an isuzu D44 for my rig -- how do I convert the pinion yoke from the Isuzu flange style to one that will accept a 1310 joint? I tried my spare regualr D44 yoke, and the Isuzu pinion uses a smaller spline. I thought about Rubi yokes or something, as I know they use the same thick gears, but thought you guys might have some insight... TIA :sunshine:

you can always go to standard gears and carriere as I did. Any drive line shop shoud be able to help. What about a 35 yoke?

I'm trying to avoid the cost of regearing for now, but I hadn't thought of a D35 yoke... anyone have one lying around they would like to donate to my experiment?

Any one else have any suggestions -- I'm looking into the D35 yoke...

You can get the flange to mate to the 1310 ujoint on the shaft side and just call it quits. Check out Rockford Driveline.