• Welcome to the new NAXJA Forum! If your password does not work, please use "Forgot your password?" link on the log-in page. Please feel free to reach out to [email protected] if we can provide any assistance.

ARB compressor mounting

It's tight, but it will fit by the power booster for the brake...

compres.jpg


Stuck the control in the console...

arbcontrol.jpg
 
Last edited:
i mounted my ARB where the stock airbox was,
and mounted the switch where the factory foglight switch was.
Picture006.jpg


Picture002.jpg
 
The original Fuseblock caught fire so i rewired it using some blocks from hella, then i made a panel and attached it to the stock bracket for the original fuseblock. on this panel i also added the MSD box and the pressure switch for the york.

808664_12_full.jpg


Then i took out the garage door opener and sunglass holder of the overhead console and built a panel to house switches. as you can see though the weight of the switches cause the plastic to bow so i'm going to build a metal panel this summer. The other compressor switch is for the york.

808664_14_full.jpg
 
You must log in or register to reply here.

Similar threads

B
Dana 30 arb locker question.
Replies
13
Views
233
Bmfinney
B
O
Routing ARB Air Lines to Rear Axle
Replies
10
Views
3K
XJlimitedx99
X
B
Vevor air pump / compressor
Replies
1
Views
2K
Rob Mayercik
R
S
All D30 lockers the same?
Replies
9
Views
470
RCP Phx
R
techno1154
PCM repair
Replies
1
Views
1K
NOTNSUV
NOTNSUV
Back
Top