Ouch,that smarts!!!

RCP Phx · Jan 10, 2005

Finally got measurements for the driveshafts for my NV241OR(Rocktrack).With 1330's at the DC joint,1310's at the axle and the "long travel" slip yokes it was $770 from Tom Woods.Also the front and rear shafts are interchangable (within 3/4") on a 4" yoke!

whoozey1953 · Jan 10, 2005

RCP Phx said:
Finally got measurements for the driveshafts for my NV241OR(Rocktrack).With 1330's at the DC joint,1310's at the axle and the "long travel" slip yokes it was $770 from Tom Woods.Also the front and rear shafts are interchangable (within 3/4") on a 4" yoke!

Did you try Dick's Driveline on McDowell?

I had my F/R done for a total of around $500.

RCP Phx · Jan 11, 2005

I chose to go to TW!Dick's and Gloeco both suck!Ive had pretty good results with Driveline Service!

RCP Phx · Jan 19, 2005

RCP Phx said:
Finally got measurements for the driveshafts for my NV241OR(Rocktrack).With 1330's at the DC joint,1310's at the axle and the "long travel" slip yokes it was $770 from Tom Woods.Also the front and rear shafts are interchangable (within 3/4") on a 4" yoke!

BillR this is for your info(both 2 1/2' shafts also)!

Loose_Nuts_Enterprises · Jan 19, 2005

Isn't that High Angle Driveline service near Phoenix? I would much rather take it to a local place that has good rep.

Dan

Loose_Nuts_Enterprises · Jan 19, 2005

Just checked....High angle driveline is in Paradise, CA. Might still be worth a call.

RCP Phx · Jan 19, 2005

Theyre allready in and loving life!Woody's are awsome!

Ouch,that smarts!!!

RCP Phx

NAXJA Forum User

whoozey1953

NAXJA Forum User

RCP Phx

NAXJA Forum User

RCP Phx

NAXJA Forum User

Loose_Nuts_Enterprises

NAXJA Member

Loose_Nuts_Enterprises

NAXJA Member

RCP Phx

NAXJA Forum User

Similar threads