- Location
- Birmingham, AL
Well I am keeping my front d30, just switching to a HP. I have decided to run the HP rear 9" I have or get an XJ D44. I really like the 65" width on the 9", but it will look weird with the stock 60" front. So my question is:
If I run 3.75" bs up front on a stock HP d30, what bs can I run on the rear to get it close to the same width as the front? (I'm running 35x12.50s)
My other option is to cut the axle down to EB width 58"? wms to wms and run those shafts. This seems like alot of work especially since I have 31 spline Mosers already and I could just bolt in a XJ D44.
My last option is to sell the HP 9" for extra $$ and buy another $85 XJ d44, which shoulden't be much less strenth than the HP 9". (Yes I get them for $85)
If I run 3.75" bs up front on a stock HP d30, what bs can I run on the rear to get it close to the same width as the front? (I'm running 35x12.50s)
My other option is to cut the axle down to EB width 58"? wms to wms and run those shafts. This seems like alot of work especially since I have 31 spline Mosers already and I could just bolt in a XJ D44.
My last option is to sell the HP 9" for extra $$ and buy another $85 XJ d44, which shoulden't be much less strenth than the HP 9". (Yes I get them for $85)
