Oldmanxj
NAXJA Member #940
- Location
- Loomis, Ca
Whats needed?
Current clearance, untouched calipers. 1/16"
Thanks Don.
Current clearance, untouched calipers. 1/16"
Thanks Don.
-
Welcome to the new NAXJA Forum! If your password does not work, please use "Forgot your password?" link on the log-in page. Please feel free to reach out to [email protected] if we can provide any assistance.
WJ brake upgrade, rim to caliper
- Thread starter Oldmanxj
- Start date
Jbh97009
NAXJA Forum User
- Location
- Damascus, Oregon
Your good, just make sure your caliper bolts are tight!!!
Oldmanxj
NAXJA Member #940
- Location
- Loomis, Ca
Will do, thanks
x-jay vision
NAXJA Forum User
- Location
- Albuquerque, NM
Are those 15 inch rims?
Oldmanxj
NAXJA Member #940
- Location
- Loomis, Ca
yes.
x-jay vision
NAXJA Forum User
- Location
- Albuquerque, NM
That's promising, I was looking to go from Teves to Akebono, now I have hope that grinding may not have to happen
mike61588
NAXJA Forum User
- Location
- Alpharetta, GA
What wheels are you running, and what's the backspacing?
Oldmanxj
NAXJA Member #940
- Location
- Loomis, Ca
Pro Comp Xtreme Alloys. 15 X 8, 4.5 bs. bought in 2002.
From the center of axle shaft to
outer edge of the caliper is 7.25"
Last edited:
831_xj
NAXJA Forum User
- Location
- Santa Cruz
Loctite and caliper bolts are one time use on those. RockAuto has em. Although mine are drilled out to 1/2" fine thread and I use redloctite every time. Has held up since the first time I lost a caliper bolt :doh:
