bent axle

So I have bent inner c's on my 2000 xj dana 30. They aren't that bad, but they are bent enough to make me notice. I was wondering if anyone else has this problem and what they did to fix it. I have another axle I could swap into it but I would rather try to fix it before I go swapping parts around.

I tried putting and angle finder on the hubs to see if I could see how far it was out but it didn't give a good reading. I just got it back from the alignment shop and they were the ones that told me how bad it was. And if it helps its the right side thats bad.

IF they really are bent, HP30s are too cheap to make fixing it worth it.

what is telling you it is bent? bad camber?

if its the stock axle from your 2000 put in a HP30 and call it a day.

Stock or lifted ? Proof/measurements of this bending ?

We made a basket with chain looped around the inner c, the placed a bottle Jack in between the basket and the diff and used that to bend them back. Then welded gussets on the c

In the end I just swapped axles