Here is a sneak peak at the rear bumper/ tire carrier that I just finished. I started with a 4x4 3/16" and built on from there. It's mounted with 2 1/2" x 3" x 1/4" posts that slide inside to the rear unibody with nutserts welded in for the gas skid. Also, mounted to the two factory positions with 1/4" plate. Built in hitch, 3/4" D rings tied into the rear posts. Quarter guards are all 1/8"
Comp4x4 1750lb spindle and sleeve for the carrier and the tire carrier in built out of 2x2 1/4" with an adjustable telescopic tire mount. latch and safety pin.
Painted rustoleum textured 7220 paint.
You can also see a sneak peak at the Tube fender flares that I built at the same time.
Comp4x4 1750lb spindle and sleeve for the carrier and the tire carrier in built out of 2x2 1/4" with an adjustable telescopic tire mount. latch and safety pin.
Painted rustoleum textured 7220 paint.
You can also see a sneak peak at the Tube fender flares that I built at the same time.
