I am going to pick up some 2"x1/4 tubing to sleeve the inside of my dana 30 axles tubes. I want to get it turned on a lathe to true up the external diameter and bring it down a bit so it slides in easy enough.
I know this had been done before but I couldn't find any info searching, how many thou should I take off the tube? I am not doing it myself so I don't want to find out it is too big and take it back.
thanks,
I know this had been done before but I couldn't find any info searching, how many thou should I take off the tube? I am not doing it myself so I don't want to find out it is too big and take it back.
thanks,
Last edited: