selarep
NAXJA Forum User
- Location
- Central CA
High Pinion D30 with Teraflex knuckles, 27 spline allow chromo shafts.
What Hub Bearings will fit? The stock hub bearings are shot, I replaced it with a new set for a 97 HP30 and it didn't seal onto the shaft. (didnt check to see if the rotor rubbed) Does it matter if the hub doesn't have an inner lip to seal onto shaft like the 97 hubs?
Picked up another set of hubs for an 86 XJ HP30, the hub will seal but it sits to flush into the knuckle, causing the rotor to seal against the inside of the knuckle.
Do I use the rotors for an 86 XJ? I don't know anything about the previous hubs or rotors.
Will the JKS hub spacer work? What about .25" washers for the 3 hub bolts?
TIA.
What Hub Bearings will fit? The stock hub bearings are shot, I replaced it with a new set for a 97 HP30 and it didn't seal onto the shaft. (didnt check to see if the rotor rubbed) Does it matter if the hub doesn't have an inner lip to seal onto shaft like the 97 hubs?
Picked up another set of hubs for an 86 XJ HP30, the hub will seal but it sits to flush into the knuckle, causing the rotor to seal against the inside of the knuckle.
Do I use the rotors for an 86 XJ? I don't know anything about the previous hubs or rotors.
Will the JKS hub spacer work? What about .25" washers for the 3 hub bolts?
TIA.