ericfx1984
NAXJA Forum User
- Location
- Kansas City Area
would 22 5/8" mid arm lowers be a good setup for 3-5" lift? or should they be longer? I can always lengthen them if need be
he was also wanting me to make the passenger side upper simple to disconnect, so he could run 3 link only on the trail...
I am going to be using stock JK front lower control arms on my buddy's XJ Heap O' Jeep...
I figure stock is 15 3/4" so they would be 6.875" longer
he is wanting to do this for several reasons...
1. cheap
2. strong
3. has bend for wider tires
4. did I mention cheap???
5. does not want long arms because they are TOO long and "will get hung up on rocks and stuff"
so should I just leave the arms JK lowers as is, or lengthen them...
he was also wanting me to make the passenger side upper simple to disconnect, so he could run 3 link only on the trail...
I am going to be using stock JK front lower control arms on my buddy's XJ Heap O' Jeep...
I figure stock is 15 3/4" so they would be 6.875" longer
he is wanting to do this for several reasons...
1. cheap
2. strong
3. has bend for wider tires
4. did I mention cheap???
5. does not want long arms because they are TOO long and "will get hung up on rocks and stuff"
so should I just leave the arms JK lowers as is, or lengthen them...