More like use the WJ TREs for at least the lower TREs connecting the two knuckles together, and either cut and tap the sleeve to the correct length or cut, insert DOM sleeve, and weld the sleeve back together to the correct length. For the drag link I am not quite sure what I would do but it would likely be something similar. However, looking at the setup I am thinking I will have to use an offset TRE at the passenger side knuckle where the drag link connects.
All of this is theoretical though. I am not willing to use anything other than Eliminator specific wheels on the truck. If I can't get the Akebono's to fit with light grinding I will see if I can source some teves calipers. If I can't get those to fit I am SOL and will have to come up with something different or live with stock brakes on a 31" or smaller tire (w dual diaphragm brake booster, SS lines, good pads, and ZJ rear brakes).