Undeclared
NAXJA Forum User
- Location
- Bay Area
Two weeks ago I was going mad trying to figure out why my jeep would crank but not run. After reading a few threads I figured it was the crank position sensor so I changed it out. After the cps did not resolve my problem I replaced the sync sensor in the distributor and bingo, the jeep ran again. Now, even though the jeep runs fine, the check engine light comes on and I get trouble code 11, which according to my manual this means there is no signal being given off by the crank position sensor. This does not make any sense because the jeep is still running.
Also, if I disconnect the battery and erase all of the codes, it takes about 20 miles of driving before the check engine light turns back on and trouble code 11 returns.
This is on a 1996 cherokee sport, 4x4, 4.0L, Auto.
Also, if I disconnect the battery and erase all of the codes, it takes about 20 miles of driving before the check engine light turns back on and trouble code 11 returns.
This is on a 1996 cherokee sport, 4x4, 4.0L, Auto.