00xj
NAXJA Forum User
- Location
- West Michigan
its for an oil slinger in the rear of a 242 tcase. Is there a "at home" tool I can use?
can I replace the oil slinger w/out it?
(step 10)
Thanks,
Tom
page 21-401 (page 1309)
(8) Slide seal onto Seal Protector 6992 (Fig. 89).
Slide seal protector and seal onto output shaft.
(9) Slide Installer C-4076-B onto seal protector
with the recessed side of the tool toward the seal.
Drive seal into rear bearing retainer with Installer
C-4076-B and Handle MD-998323 (Fig. 90).
(10) Install rear slinger with Installer 8408.
(11) Install boot on output shaft slinger and crimp
retaining clamp with tool C-4975-A (Fig. 91).
can I replace the oil slinger w/out it?
(step 10)
Thanks,
Tom
page 21-401 (page 1309)
(8) Slide seal onto Seal Protector 6992 (Fig. 89).
Slide seal protector and seal onto output shaft.
(9) Slide Installer C-4076-B onto seal protector
with the recessed side of the tool toward the seal.
Drive seal into rear bearing retainer with Installer
C-4076-B and Handle MD-998323 (Fig. 90).
(10) Install rear slinger with Installer 8408.
(11) Install boot on output shaft slinger and crimp
retaining clamp with tool C-4975-A (Fig. 91).