mcdavid123
NAXJA Forum User
- Location
- Raynham, MA
Just picked up a 29 spline 8.25 to replace my 27 spline and am wondering if it's worth welding the tubes to the housing? I'm running 3.55's / 31's and plan on putting a No-Slip in it. Down the line at most i'll be swapping in 4.56's and run 33's.
Now if it is worth welding (figured why not, while its out), does anyone know the best way to go about doing this? Is MIG ok or should it definitely be Arch'd? I've read that if the housing is cast steel, you're good to go but cast iron needs some careful attention. Anyone know which the 8.25 is?
I tried searching but didnt really come up with anything on the 8.25. If anyone has any previous links they could shoot me or any insight that would be great.
Thanks in advance
Now if it is worth welding (figured why not, while its out), does anyone know the best way to go about doing this? Is MIG ok or should it definitely be Arch'd? I've read that if the housing is cast steel, you're good to go but cast iron needs some careful attention. Anyone know which the 8.25 is?
I tried searching but didnt really come up with anything on the 8.25. If anyone has any previous links they could shoot me or any insight that would be great.
Thanks in advance