boise49ers
NAXJA Forum User
- Location
- Boise,Idaho
I just put in a new thermostat when I replaced my Housing gasket because it leaked. Well I thought I burped it and it was pushing small amounts of coolant through the Water pump weep hole. Then I realized I hadn't burped it with the heater on. So I have reburped it with the heater on and now it seems to be holding and not seeping any more.
My question is if it pushed it past the seal in the waterpump does that mean it is getting ready to call it quits or is that pretty common when there is too much air in the system. That doesn't push coolant into the bearing where it'll corrode and ruin them does it ?
My question is if it pushed it past the seal in the waterpump does that mean it is getting ready to call it quits or is that pretty common when there is too much air in the system. That doesn't push coolant into the bearing where it'll corrode and ruin them does it ?