- Location
- Billings MT/Rapid City SD
Have a leak between the transmission and t-case. I just installed a 3/8" clocking ring and from searching I found I need a transmission seal spacer as mine is leaking, alot. Transmission is leaking not the t-case.
Also found Teraflex has it, part # 2904400, but it is out of stock. The picture shows a C-A 1011 number on it but Google doesn't bring anything up. So my question is can I make a spacer for the seal or does it need to be a one piece unit as the Teraflex seems to be.
Also the pic attached it the tail-shaft housing for the transmission, should the be a seal or RTV around the larger outside circle or is that just a metal to metal fit? Sorta in the area of the red line.
Man this sucks having to remove all this junk again. ugh, wish the clocking ring instructions would have mentioned this tidbit.
Also found Teraflex has it, part # 2904400, but it is out of stock. The picture shows a C-A 1011 number on it but Google doesn't bring anything up. So my question is can I make a spacer for the seal or does it need to be a one piece unit as the Teraflex seems to be.
Also the pic attached it the tail-shaft housing for the transmission, should the be a seal or RTV around the larger outside circle or is that just a metal to metal fit? Sorta in the area of the red line.
Man this sucks having to remove all this junk again. ugh, wish the clocking ring instructions would have mentioned this tidbit.