track bar Heim

[nitrospeed]

So does anyone have sujestions on, if I took my heim joint off my procomp trackbar where to take it to be sized up in the portland, vancouver area. I would like to know the size of the shank and thread pitch, od and id. I am thinking of doing a jonny joint. what do you guys think?

 

[BPB]

You could try measuring it with a tape measure, the threads are fairly common from what I have seen. But as long as you don't buy anything from them, Woody's could probably help you out.

 

[hards91xj]

Mine was a 3/4 18 thread , I ordered 2 from Jegs .Installed them 3 months ago. so far no problem I also made my own bracket to mount it to the origanal trac bar mount on the body side.

 

[nitrospeed]

was that on a procomp part? I hope the procomp jtb400 trackbar does not have odd threads. what was your ID of your heim and does yours use the sleeve?

 

[WheelinJR]

I'd be pretty sure they use a standard 3/4 - 3/4 heim. Run it down to Oregon Motorsports 2000 on Hwy 212

 

[nitrospeed]

I found all my info.. thanks guys

 

[BPB]

I'd be pretty sure they use a standard 3/4 - 3/4 heim. Run it down to Oregon Motorsports 2000 on Hwy 212

Are they reasonable? I hate buying stuff online.

 

[RedJeep2.0]

I'd be pretty sure they use a standard 3/4 - 3/4 heim. Run it down to Oregon Motorsports 2000 on Hwy 212

X2 chris is a cool guy!

 

[crazycracka]

I'd be pretty sure they use a standard 3/4 - 3/4 heim. Run it down to Oregon Motorsports 2000 on Hwy 212

Dude serious, I just asked you the other day were I could get one and you told me "Eh check around the shops". Ass. lol

 

[BPB]

Dude serious, I just asked you the other day were I could get one and you told me "Eh check around the shops". Ass. lol

Lol

 

[WheelinJR]

Dude serious, I just asked you the other day were I could get one and you told me "Eh check around the shops". Ass. lol

That is one of the shops, lol.

From my EVO 4g Tapatalk