Begster
NAXJA Forum User
- Location
- Cape Cod/Boston, Mass
Alright, I finished installing my RE hack and tape SYE yesterday, drove it around yesterday and today, it was awsome. I didn't have a chance to take the 1" T-case drop kit out because my air compressor broke.
My Jeep is a '99, and my crossmember was a little bent, so I was up at my shop today and took a crossmember out of an early 90's cherokee, they looked identical when I had them both out. I swaped it in and took out the drop kit.
I go to move it, and now im hearing a clunking like somethings hitting. I drove less than 10mph just to drive from the back to the front of the shop, and new there was no way I could get it home. Its cold and wet outside, we looked under it briefly and we couldn't see any immediate problems.
Any Ideas? put old crossmember back in? put drop kit back in?
My Jeep is a '99, and my crossmember was a little bent, so I was up at my shop today and took a crossmember out of an early 90's cherokee, they looked identical when I had them both out. I swaped it in and took out the drop kit.
I go to move it, and now im hearing a clunking like somethings hitting. I drove less than 10mph just to drive from the back to the front of the shop, and new there was no way I could get it home. Its cold and wet outside, we looked under it briefly and we couldn't see any immediate problems.
Any Ideas? put old crossmember back in? put drop kit back in?