I wish I could go back to '96, before time and rust and all that good stuff set in on all of my bolts...So I'm putting my lift on tonight, it's a RE 3.5" kit w/ rear leafs. I started on the front and went to take the lower control arms off but the end that attaches to the frame is horribly frozen. I'm pretty sure that the bolt is stuck on the bushings because it will not come out. If anybody else has dealt with this what did you do to get past it? I tried to sawzall through the bolts but can't get in at the right angle and I'm cutting through the metal that hugs the bushings, looks like reinforcement, and I'm sure that cutting through that would be bad.
Also, the studs on the bottom of the sway bar links that take the torx head are stuck too. I'm not sure if those are supposed to unscrew out of there or if they just pound out. Somebody has to have had these problems before, help!
Also, the studs on the bottom of the sway bar links that take the torx head are stuck too. I'm not sure if those are supposed to unscrew out of there or if they just pound out. Somebody has to have had these problems before, help!