SharkXJ
NAXJA Member #1177
- Location
- San Jose, CA
I have the RE 4.5" kit installed along with an SYE and CV Driveshaft. I need to correct the angle of the axel by about 5 degrees.
Here's my question: When I install the shims the centering pin will no longer sit in the hole in the spring perch. How do I correct this? I called RE and he said I needed to insert some sort of spacer to get the pin in the perch. There is not a whole lot of thread at the top of the bolt in the spring. How do I go about doing this?
Oh - I don't want to spend the $$$ on an 8.25 to have the perches re-welded with the correct angle.
Thanks in advance.
Here's my question: When I install the shims the centering pin will no longer sit in the hole in the spring perch. How do I correct this? I called RE and he said I needed to insert some sort of spacer to get the pin in the perch. There is not a whole lot of thread at the top of the bolt in the spring. How do I go about doing this?
Oh - I don't want to spend the $$$ on an 8.25 to have the perches re-welded with the correct angle.
Thanks in advance.