O-Gauge Steamer
NAXJA Forum User
- Location
- Colorado Springs, Colorado
Over time, carbon builds up in the motor causing several problems. Sometimes the electric fan starts running erratically, like it does not always want to start. Sometimes, when you turn them by hand, you will feel them "cog". By this I mean that it feels like it is going past notches. A DC motor should turn smoothly.
Here is how to reclaim a 97+ Fan Motor.
1. Remove the C-Clip and metal spacer securing the blade to the motor.
2. Remove the blade from the shaft. Tap the motor shaft LIGHTLY to get it off. DO NOT PRY ON THE BLADES, THEY WILL SHATTER!!!!!!
3. Remove the three screw securing the motor to the shroud.
4. There are several tabs that are bent down holding the backing plate. Gently pry these up to release the backing plate.
5. Blow out the built up carbon dust from the inside of the motor. As the motor operates, the brushes wear depositing carbon everywhere. This shorts the segments causing the "Cog" feel.
6. Gently clean between the commutator segments to remove the carbon. A very small scribe works well.
7. Reattach the backing plate by gently bending the tabs back into place.
8. Reattach motor to shroud.
9. Reattach blade.
10. Test.
This is a, usually, one time repair as the tabs holding the back plate on tend to snap off with repeated bendings as they are just thin sheet steel. It is also possible to just buy the motor by itself. Google the part number that is printed on the motor. It is a Bosch Part.
Here is how to reclaim a 97+ Fan Motor.
1. Remove the C-Clip and metal spacer securing the blade to the motor.
2. Remove the blade from the shaft. Tap the motor shaft LIGHTLY to get it off. DO NOT PRY ON THE BLADES, THEY WILL SHATTER!!!!!!
3. Remove the three screw securing the motor to the shroud.
4. There are several tabs that are bent down holding the backing plate. Gently pry these up to release the backing plate.
5. Blow out the built up carbon dust from the inside of the motor. As the motor operates, the brushes wear depositing carbon everywhere. This shorts the segments causing the "Cog" feel.
6. Gently clean between the commutator segments to remove the carbon. A very small scribe works well.
7. Reattach the backing plate by gently bending the tabs back into place.
8. Reattach motor to shroud.
9. Reattach blade.
10. Test.
This is a, usually, one time repair as the tabs holding the back plate on tend to snap off with repeated bendings as they are just thin sheet steel. It is also possible to just buy the motor by itself. Google the part number that is printed on the motor. It is a Bosch Part.