A few years ago I had to weld the hinges back on and everything seemed ok except for some closing issues I never could get quite right.
After I got back a few weeks ago I noticed it was getting pretty bad. Looked around and the door skin spot welds were broke loose. So I pulled the doors up and tacked them back on. That is when I realized they probably let go because of some bad missalignment.
The door is still about 1" low all the way accross the top. It's square until it's closed, but way low. I can't find any play in the hinges. I was looking for some spreading on the door side and didn't see any there.
I was going to pull them anyway and change the pins and check the fit. What else do I need to look for? There isn't enough adjustment to get it high enough. Could the hinges be bent enough to lower it equally front to back?
Clueless,
Lincoln
After I got back a few weeks ago I noticed it was getting pretty bad. Looked around and the door skin spot welds were broke loose. So I pulled the doors up and tacked them back on. That is when I realized they probably let go because of some bad missalignment.
The door is still about 1" low all the way accross the top. It's square until it's closed, but way low. I can't find any play in the hinges. I was looking for some spreading on the door side and didn't see any there.
I was going to pull them anyway and change the pins and check the fit. What else do I need to look for? There isn't enough adjustment to get it high enough. Could the hinges be bent enough to lower it equally front to back?
Clueless,
Lincoln