shawnxj
NAXJA Forum User
- Location
- portland, tx
built a stroker motor for my renix. starts up and idles just fine but wouldn't rev over 3000 rpm in park or driving around. replaced the cam sensor cause it was the only sensor i couldn't test since i don't have an analog meter. started it up and now it won't rev past 2500 rpm. figured i'd replace the cps as well since it was old and probably wasn't reading right under higher rpm. tested fine at idle but didn't check it any higher. well that knocked my rev limiter down to 2200 rpm
idle quality is as perfect as gets. i've moved the distributor 1 tooth back and it starts running really rough. guess i could move it 1 tooth forward and see what it does but it would put the rotor at 6 o-clock which would be too far forward.
tomorrow i'm going to put the old distributor back in and leave the new cps in and see what it does. might move 1 tooth forward as well. any other advise or help would be appreciated
idle quality is as perfect as gets. i've moved the distributor 1 tooth back and it starts running really rough. guess i could move it 1 tooth forward and see what it does but it would put the rotor at 6 o-clock which would be too far forward.
tomorrow i'm going to put the old distributor back in and leave the new cps in and see what it does. might move 1 tooth forward as well. any other advise or help would be appreciated