POLAR_JEEP_04
NAXJA Forum User
- Location
- Ohio
planing on running full-width only because I don't have the means to narrow them.
-
Welcome to the new NAXJA Forum! If your password does not work, please use "Forgot your password?" link on the log-in page. Please feel free to reach out to [email protected] if we can provide any assistance.
rear dana 60 35spline upgrade Q
- Thread starter POLAR_JEEP_04
- Start date
Durango-Bob
NAXJA Forum User
- Location
- Greensburg, PA
OK, I found this link that may be helpful even if you are not going to narrow it:
http://www.bsfab.net/?p=22
I haven't found a good source for the machining work but I'm still checking.
http://www.bsfab.net/?p=22
I haven't found a good source for the machining work but I'm still checking.
Sierra Drifter
NAXJA Forum User
- Location
- San Ramon Ca
YA FF35-36.5 [21233]
Yukon 1541H alloy rear axle for Dana Spicer 60, 70, and 80 with a length of 34 to 36.5 inches and 35 splines. Yukon 1541H alloy axles offer a strength increase over stock while retaining a low cost. Yukon 1541H alloy rear axles come with a five year warranty against manufacturing defects. This is a full-floating axle.
http://www.yukongear.com/ProductDetails.aspx?ProdID=3868
Moser makes a better non-tappered shaft but they are expensive.
Last edited:
