Black1990jeep
NAXJA Forum User
- Location
- california
Hi. I have a modified jeep that has Warn manual lock hubs. I takes the 30 spline large UJoint (5-760x) stub axle. I have found the Yukon W38248 part to be the correct replacement as mine have a pitted needle bearing race. I ordered 2 from Motorsport supply, both arrived with dings on the bearing race. They then sent a second set, dropped shipped straight from Yukon. The second set was worse, dinged race on one, the other was used, red axle grease and sand on the splines, scuff marks and hammer blows from a Ujoint install and removal and rust on the race!
Does anyone have another source for this stub axle? Does anyone other than Yukon make them? I have heard these also fit CJ7 and Scout trucks.
4 ordered, all four have defects, the used one sent was over the top bad. Nicks on the bearing race is unacceptable.
It it too much to ask for clean ding free bearing race?
Comments, advice?
Does anyone have another source for this stub axle? Does anyone other than Yukon make them? I have heard these also fit CJ7 and Scout trucks.
4 ordered, all four have defects, the used one sent was over the top bad. Nicks on the bearing race is unacceptable.
It it too much to ask for clean ding free bearing race?
Comments, advice?