- Location
- Williams AZ
So, has anybody run into something like this.
I pulled a 231 tcase from a 05 liberty due to noise/vibration at 50mph and the case running what I considered too hot (over 200 degrees with no load).
Cracked it open and found small chips of aluminum inside. Seems they are coming from the shift fork rod spring. It appears to be walking in a circle and the end of the spring is biting little chunks out of the housing (the chunks remind me of porting debris from porting aluminum heads). Should there be a washer on the end of the shaft between the case and the spring??? Anybody have a blow apart with good detail in that area?
I pulled a 231 tcase from a 05 liberty due to noise/vibration at 50mph and the case running what I considered too hot (over 200 degrees with no load).
Cracked it open and found small chips of aluminum inside. Seems they are coming from the shift fork rod spring. It appears to be walking in a circle and the end of the spring is biting little chunks out of the housing (the chunks remind me of porting debris from porting aluminum heads). Should there be a washer on the end of the shaft between the case and the spring??? Anybody have a blow apart with good detail in that area?