bhicks
NAXJA Forum User
- Location
- Forest Falls, CA
I bought some JCR rear quarter guards from djblade that needed some modifying to fit my rig. I made all the cuts to the 3/16th plate but bending it is becoming VERY difficult. I heated it up with a torch until it was red hot and put all my weight on it and still couldn't get it to bend. I even took a few wacks at it with my 8lb sledge and nothing. I need to put about 10 degrees more bend in the top section. I don't know the name of the machine, but I need to find a shop that can bend sheet metal. I already made a template to go by. Any advice or shop info would be appreciated.