LCA and UCA bushing sleeves

[vetteboy]

I used 2.75" x .25 wall DOM.

I just pressed the bushings in, no machining required. Needed about 10 tons to get past the step.

 

[gorman]

the axle mount for the upper control arm is the same as a sleeve in an upper control arm.

Thanks, I'll have a look at the upper mount - I was under the impression that the right hand upper control arm mount was similar to the lower control arms and didn't have a sleeve - I'll check it out.

I used 2.75" x .25 wall DOM.

I just pressed the bushings in, no machining required. Needed about 10 tons to get past the step.

This is some real usefull info, thanks! By far the easiest method of all.