AZCA jeeper
NAXJA Forum User
- Location
- Phoenix, AZ
After searching I've found two ways to mount remote reservoir shocks in the rear: Cut through the floor and mount the reservoirs inside the cab or mount the reservoirs onto the shock body. Now, I'll only be running 10" travel 2.0 shocks, so they aren't so massive I'll need to start cutting the floor away....right?
Now, what I didn't find was how to mount the eye at the top of the shock. The bottom eye is straight forward, just slip it onto the bolt and tighten the nut down. But at the top it's a different story. On my old shocks there is a "prong" or "fork" (best way I can describe it, I do not know the real term) that goes through the eye. Do I just take these out and put them in the new shocks? From the old shock in my hand to the picture of the Fox 2.0's online the eyes look very different, so I'm not sure if the "forks" will fit.:dunno:
I apologize for my lack of knowledge but I'm trying to learn.:looser:
Now, what I didn't find was how to mount the eye at the top of the shock. The bottom eye is straight forward, just slip it onto the bolt and tighten the nut down. But at the top it's a different story. On my old shocks there is a "prong" or "fork" (best way I can describe it, I do not know the real term) that goes through the eye. Do I just take these out and put them in the new shocks? From the old shock in my hand to the picture of the Fox 2.0's online the eyes look very different, so I'm not sure if the "forks" will fit.:dunno:
I apologize for my lack of knowledge but I'm trying to learn.:looser: