HobHayward
NAXJA Forum User
- Location
- MA
In process of re-gearing my hpd30.
This was my pattern when I was using setup bearings, was pretty pumped as this was the first pattern I got after setting up the backlash:
With the real bearings and races pressed in I end up with .0035" of ring gear runout on the diameter (not sure what it was prior). Backlash measures .005-.007 (measured in like 10 different locations..) which looks to be in spec. However my pattern went to this:
Looks like I need to back the pinion off a hair , but its close, some spots look more passable than others. Only problem is I don't think I can get the inner pinion race out without mangling the baffle.. which I would need to order a replacement for.
Any thoughts?
This was my pattern when I was using setup bearings, was pretty pumped as this was the first pattern I got after setting up the backlash:
With the real bearings and races pressed in I end up with .0035" of ring gear runout on the diameter (not sure what it was prior). Backlash measures .005-.007 (measured in like 10 different locations..) which looks to be in spec. However my pattern went to this:
Looks like I need to back the pinion off a hair , but its close, some spots look more passable than others. Only problem is I don't think I can get the inner pinion race out without mangling the baffle.. which I would need to order a replacement for.
Any thoughts?