So in the process of front waggy 44 swap. I was going to just run the steering flipped to the top of the knuckle but ran across a set of waggy flat top knuckles for cheap so now I’m looking into high steer.
I have done some researching, just need some more info. Is this the kit I would need for the arms? It says it has a 10 degree correction, what does that mean?
http://www.partsmike.com/store/store.php?crn=204&rn=1343&action=show_detail
I have access to a mill, has any one machined their knuckles themselves? I’m not a master machinist but have used it quite a bit.
Thanks for any help,
Pete
I have done some researching, just need some more info. Is this the kit I would need for the arms? It says it has a 10 degree correction, what does that mean?
http://www.partsmike.com/store/store.php?crn=204&rn=1343&action=show_detail
I have access to a mill, has any one machined their knuckles themselves? I’m not a master machinist but have used it quite a bit.
Thanks for any help,
Pete