kirby
NAXJA Forum User
- Location
- South Weber
I have a full width d44 pass side drop that I'm putting in a 98'. For those of you that had to tackle the stupid cast in spring pad on the differential how did you mount the coil brackets? I'm going to use the stock coil mounts that I took off another d30. As far as I could tell from my measurements the brackets would be 1 3/4 wider than stock width if mounted next to the cast mount which would angle the coils considerably. Is this angle too much? Or will that have no affect on performance? Can you grind the cast mount down far enough to move the coil mount over on top of it? If I did put the mount butt up with the cast mount where would I put the truss I would need for the upper control arm mount? Also where would the trackbar fit since the diff is on the side it needs to mount to? Will it clear the front of the cover? Any help would be appreciated. If I have to weld to the cast I'll have to take it in to a shop, but I can do the rest if it's just MIG. Close pics would be great help also.
Thanks
Lyle
Thanks
Lyle