sh!nny
NAXJA Forum User
- Location
- Littleton CO
so im kinda frustrated - just did new coil buckets etc on a dana 30 hp.
i think i might have had a faulty angle finder cuz now after finishing the angles visually looked more extreme - using a different angle finder i found that the pinion is sitting at 13.4degrees up, the Inner C measring from the flat of the lower ball joint is at -2degrees and the coil bucket sits at 0 degrees.
how ****ed am i? i do have long arms etc, and i did plan on pushing the axle forward about an inch.
do i need to cut out my coil buckets and re do them or would i be ok with just adjusting the arms?
i think i might have had a faulty angle finder cuz now after finishing the angles visually looked more extreme - using a different angle finder i found that the pinion is sitting at 13.4degrees up, the Inner C measring from the flat of the lower ball joint is at -2degrees and the coil bucket sits at 0 degrees.
how ****ed am i? i do have long arms etc, and i did plan on pushing the axle forward about an inch.
do i need to cut out my coil buckets and re do them or would i be ok with just adjusting the arms?