I went to replace my calipers and am having some problems.
The bolt that held the old brake line on he caliper had a washer between the bolt and the line. I replaced the line on the new caliper and it leaked like hell. If I put the washer between the line and the caliper it's fine, or if I don't use the washer it's fine. Is this bad? Which way should I do it.
Also, my meat head nephew pressed the brake pedal while the cap was off under the hood. Did this basically fill the entire system with air? We are having a hell of a time bleeding the system. Should I be doing all four corners? Thanks
The bolt that held the old brake line on he caliper had a washer between the bolt and the line. I replaced the line on the new caliper and it leaked like hell. If I put the washer between the line and the caliper it's fine, or if I don't use the washer it's fine. Is this bad? Which way should I do it.
Also, my meat head nephew pressed the brake pedal while the cap was off under the hood. Did this basically fill the entire system with air? We are having a hell of a time bleeding the system. Should I be doing all four corners? Thanks