cherokee4fun
NAXJA Forum User
- Location
- Bend, Oregon
Hi there,
So, I still have some goofy noise coming from the front end on my 90 XJ when I go to 4wd. I want to do something with the CAD system on the axle.
So a few questions:
1. If I take it apart and want to put washers in so that the axle will stay connected, is there a real write up? I assume I am just putting washers between the fork and the housing.
2. If I do the washers, do I need to disconnect the vaccum hose to the fork?
3. Can I leave the vaccum hose so that switch changes to show that I am in 4wd?
I was just going to get another axle, but I just replaced the u-joints on the axle about 6k miles ago.......
Any other suggetions would be appreciated.
Thanks,
Bob
So, I still have some goofy noise coming from the front end on my 90 XJ when I go to 4wd. I want to do something with the CAD system on the axle.
So a few questions:
1. If I take it apart and want to put washers in so that the axle will stay connected, is there a real write up? I assume I am just putting washers between the fork and the housing.
2. If I do the washers, do I need to disconnect the vaccum hose to the fork?
3. Can I leave the vaccum hose so that switch changes to show that I am in 4wd?
I was just going to get another axle, but I just replaced the u-joints on the axle about 6k miles ago.......
Any other suggetions would be appreciated.
Thanks,
Bob