I bought a D30 aussie used from a friend. I helped him install it when he bought it so i'm not worried about that but we never checked the tolerances because he didn't care. i want to check them when i put it in my rig but i don't have the directions... does anybody have an electronic copy of their installation instructions? i think i understand the center gap measurement but it says to use feeler gauges for the spacer tolerance. is there a way to do it with a micrometer? also, are these the correct specs?
Center gap (SPEC= .145- .170)
between spacers and pinion shaft (SPEC=.006-.020)
and one last thought, i remember seeing a tolerance for cross pin wear... does anyone have specs on that (new part dimensions)?
Thanks!
Center gap (SPEC= .145- .170)
between spacers and pinion shaft (SPEC=.006-.020)
and one last thought, i remember seeing a tolerance for cross pin wear... does anyone have specs on that (new part dimensions)?
Thanks!
Last edited: